How To Clean Kel Tec Sub 2000

The Kel Tec SUB-2000 is a semi-automatic rifle that folds in half for easy storage and transport. It is chambered in 9mm Luger and can accept Glock magazines. The SUB-2000 has a Picatinny rail on the top of the receiver, making it easy to mount optics. Because the barrel is interchangeable, different calibers can be used by swapping out the barrel.

How To Clean Kel Tec Sub 2000

To clean the Kel Tec Sub 2000, it is best to start by disassembling the weapon. This can be done by removing the magazine, pulling the charging handle to the rear, and then pushing the takedown pin out from the left side. The bolt carrier and recoil spring can then be removed. Next, the barrel can be unscrewed from the receiver. Finally, use a brush and solvent to clean all of the parts. Be sure to allow all of the parts to dry

-Kel Tec Sub 2000 Cleaning Rod -Brush- Patches -Gun Oil

  • Use a brush to clean out any dirt or fouling from inside the barrel
  • Open the bolt and lock it back
  • Inspect
  • Check if there is a magazine in the gun and remove it if there is

– Check the manufacturer’s cleaning instructions first – Make sure you have the correct type of cleaning kit – Clean the barrel using a bore brush and solvent – Clean the receiver and bolt with a brush and solvent – Clean the magazine using a brush and solvent (or just replace it) – Lubricate all moving parts


Frequently Asked Questions

Is Kel-Tec Sub 2000 Considered An Ar?

A: The Kel-Tec Sub 2000 is a rifle that can be classified as an AR. It is designed to shoot .40 caliber rounds and has a capacity of 16 rounds.

Can You Carry A Kel-Tec Sub 2000?

Yes, the Kel-Tec Sub 2000 can be carried. It is a small and lightweight rifle that can easily be transported in a backpack or bag.

Is The Kel Tec 2000 A Rifle?

Kel Tec 2000 is not a rifle.


To Summarize

The Kel Tec Sub 2000 is a great firearm to own. It is easy to clean and maintain. To clean the Kel Tec Sub 2000, you will need to remove the barrel, bolt, and magazine. You can then clean the barrel and bolt with a brush and solvent. Be sure to clean the inside of the barrel and bolt with a brush as well. You can then reassemble the firearm.

Leave a Comment