How To Clean Racor Filter Bowl

The Racor filter bowl is one of the most important parts of the Racor fuel filter system. The bowl must be kept clean to ensure proper fuel filtration. There are several methods for cleaning the Racor filter bowl, but the most common is to use a wire brush.

How To Clean Racor Filter Bowl

Racor filters are designed to remove contaminants from the fuel system of a vehicle. The filter bowl is the part of the filter that holds the collected contaminants. Over time, the filter bowl can become dirty and need to be cleaned. Cleaning the Racor filter bowl is a simple process that can be completed in a few minutes. To clean the Racor filter bowl, first make sure that the engine is turned off and that the fuel tank is empty. Then,

-Racor filter bowl -degreaser -soap -water -hose

  • Rinse the bowl and element with fresh fuel. reinstall the
  • Open the filter bowl lid by unscrewing it counterclockwise
  • Remove the old fuel filter element by pulling it out of the bowl

-The racor filter bowl should be cleaned every time the filter is replaced or serviced. -To clean the racor filter bowl, use a soft brush and mild detergent. -Be sure to rinse the bowl thoroughly before reinstalling the filter.


Frequently Asked Questions

How Do You Drain A Racor Fuel Water Separator?

To drain a Racor fuel water separator, first remove the bowl from the top of the unit. Next, locate the drain valve at the bottom of the bowl and open it. Allow the water to drain out until it is clear. Finally, reinstall the bowl and close the drain valve.

Do You Completely Drain A Water Separator?

No, typically not. Draining the separator will remove any water that has built up in the unit, but it will not remove all of the water from the fuel.

How Do You Clean A Fuel Water Separator?

The best way to clean a fuel water separator is to first disconnect the fuel line and then flush it with solvent. Next, remove the separator element and clean it with solvent. Finally, reinstall the separator element and reconnect the fuel line.


In Closing

The Racor filter bowl can be cleaned with soap and water. The Racor filter should be removed from the bowl and the filter elements cleaned. The bowl can then be rinsed with water.

Leave a Comment