How To Clean Roller Skate Bearings

Cleaning roller skate bearings is an important part of roller skating. If bearings are not clean, they will not roll as smoothly and may cause the skate to wobble. There are a few different ways to clean bearings, depending on what type of bearings they are.

How To Clean Roller Skate Bearings

The process of cleaning roller skate bearings is not a difficult one, but it is important that it is done properly in order to maintain the performance and longevity of the bearings. The first step is to remove the shields on each side of the bearing. There is usually a small tab on one end of the shield that can be pulled out with a fingernail in order to remove it. Once the shields are off, the next step is to clean off all of the old grease and dirt from

– Bearing cleaning kit – Mild soap – Warm water – Bucket or container – Toothbrush

  • Get a bowl of hot water and put the bearings in it let the bearings soak for 1015 minutes take a
  • Take out the bearings from the wheels
  • Take off the wheels of the roller skates

-keep bearings clean to ensure good performance -use a cleaning solvent such as rubbing alcohol or kerosene -use a brush to remove debris -rinse with water

Frequently Asked Questions

Can You Clean Roller Skate Bearings With Alcohol?

Yes, you can clean roller skate bearings with alcohol. However, you should avoid using too much alcohol, as it can dissolve the bearing’s lubricant.

Can I Use 70% Alcohol To Clean Bearings?

Yes, you can use 70% alcohol to clean bearings. Alcohol is a solvent that will dissolve oils and other contaminants, making it an ideal choice for cleaning bearings. Just make sure to rinse the bearings thoroughly with water after cleaning to remove any residual alcohol.

What Liquid Can I Use To Clean My Bearings?

WD-40 is a popular choice for cleaning bearings, as it is a degreaser and lubricant. Other options include Simple Green, motor oil, or kerosene.


Cleaning roller skate bearings is not a difficult process, but it is important to do it correctly in order to ensure that the bearings remain in good condition. The steps involved are: 1. Remove the skate wheels from the skates. 2. Use a solvent such as rubbing alcohol or mineral spirits to clean the bearings and the inside of the wheel hub. 3. Dry off the bearings and the wheel hub with a cloth. 4. Re-lubricate the bearings with a quality skate bearing lubricant.

Leave a Comment

Your email address will not be published.